Banks County |
Code of Ordinances |
Chapter 18. BUILDINGS AND BUILDING REGULATIONS |
Article III. ADMINISTRATIVE PROCEDURES |
§ 18-81. Posting floor loads.
(a)
Occupancy. An existing or new building shall not be occupied for any purpose which will cause the floors thereof to be loaded beyond their safe capacity. The building official may permit occupancy of a building for mercantile, commercial, or industrial purposes, by a specific business, when he is satisfied that such capacity will not thereby be exceeded.
(b)
Storage and factory-industrial occupancies. It shall be the responsibility of the owner, agent, proprietor or occupant of Group S and Group F occupancies, or any occupancy where excessive floor loading is likely to occur, to employ a competent architect or engineer state the safe allowable floor load on each floor in pounds per square feet uniformly distributed. The computations and affidavit shall be filed as a permanent record of the building department.
(c)
Signs required. In every building or part of a building used for storage, industrial or hazardous purposes, the safe floor loads, as reviewed by the building official on the plan, shall be marked on plates or approved design which shall be supplied and securely affixed by the owner of the building in a conspicuous place in each story to which they relate. Such plates shall not be removed or defaced, and if lost removed or defaced, shall be replaced by the owner of the building.
(Ord. No. 99-5, § 3.10, 5-18-1999)